Apek Maxpad User's Guide download pdf (Page 13)

Installation 13

4.Lineuptherods“1A”and“1B”totheholesofthecentralmoduleandscrewwith

the aid of a screwdriver which follows the support, according to the drawing of the

previous Page;

5.Fixthepiece“2A”onthechosenwall(whichshouldemadeofbrickandrm

enough to hold the weight is 175 pounds). In order to make the work easier it is

recommendedtousethepiece“2A”asastretchtomarkandmaketheholesonthe

wall,asshowninthenextpage.Withtheplugsxedonthewallplacethepiece“2A”

on the wall, use the four screws with thread (also supplied with the accessory).

BeforexingtheMaxpadTMonthewall,makesurethatthepiece“2A”isrmand

that there is no risk of fall. Apek is not responsible for the accidents caused by the

bad Installation of these supports.

6. If you intend to install the Set top box of your cable TV to the cable of MaxpadTM,

alsousethepiece“2B”,ttinginwiththepiece“2A”,accordingtothepictureon

page15;

HINT APEK: BEFORE FITTING IN THE MAXPAD™ ON THE WALL, IT IS RECOM-

MENDED THAT THE ELECTRICAL WIRING CONNECTIONS AND THE INTERNET

WEB (IF AVAILABLE) ARE INSTALLED.THE APEK WALL SUPPORT STILL OFFERS

AN ADDITIONAL SUPPORT (OPTIONAL) TO FIX YOUR SET TOP BOX OF THE

CABLE TV. IF YOU CHOOSE TO USE IT, LEAVE IT SCREWED ON THE LOCAL

BEFORE FITTING IN THE MAXPAD™ ON THE WALL.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

No comments

Apek Maxpad User's Guide Page 13